Logitech G X56 HOTAS Throttle Mode Switch Potentiometer Replacement

ID: 185367

Description: Over time, the mode switch on your Logitech G...

Steps:

1. Remove the eight 8.6 mm long 1.5 mm hex screws from the label plate.

2. Use an opening tool to pry off the mode switch knob.

3. Remove the eight 12.5 mm long Phillips #1 screws from the underside of the label plate.
4. These screws are plastic! Be very careful when applying force.

5. Place the throttle right side up again, using the bottom panel as a coaster.
6. Gently pry the label plate from the body of the throttle.

7. Use an 11 mm deep socket to remove the nut from the post of the switch.

8. Flip the throttle over.
9. The mode switch potentiometer is identifiable by the orange plastic contact board.
10. Disconnect the potentiometer connector from the PCB by pulling it straight up and out of its socket.

11. Gently remove the mode switch potentiometer by pulling it straight out of the base plate.