Sony SRS-XG300 Tweeter Replacement

ID: 185705

Description: If your Sony SRS-XG300 (model XG300) is...

Steps:

1. Before beginning, make sure to unplug and power off your speaker.
2. With the Sony label on the left, roll the speaker horizontally to the bottom of the speaker with the rubber stands.
3. Remove four 12 mm screws with a Phillips #1 screwdriver.
4. Remove the loose rubber feet.

5. Insert the metal spudger tool at 90-degree angle into the right part of seam.
6. Pry off the top part of the fabric cover using the metal spudger.
7. Follow the seam to completely detach the top part of the fabric cover.
8. Repeat to remove the bottom part of the fabric cover.

9. Unclip all six trapezoid-shaped notches around the rim of the speaker using the metal spudger.
10. Begin at the end of the speaker volume button board for an easier process.
11. You may have to work clips off, pushing away from the speaker simultaneously.
12. Remove the speaker mounting ring.
13. Repeat the same steps on the other end of the speaker with the power button board.

14. Remove the four 12 mm screws on the corners of each tweeter using the Phillips #1 screwdriver.
15. The tweeters are smaller compared to the two woofers in the center of the speaker.

16. Lift the right tweeter up to expose the connected cables at the top and bottom of the right tweeter.
17. Pinch down on the metal tab and pull outward to disconnect each cable.
18. Pieces are malleable, so you may have to maneuver to disconnect.
19. Lift the right tweeter up and out of the case.

20. Remove the six 12 mm screws on the rim of the radiator using the Phillips #1 screwdriver.
21. Uncap the left bass radiator. Detach the blue ribbon cable from the bass radiator.
22. Using the angled tweezers will make this process easier.
23. Remove the left bass radiator.

24. Disconnect the microphone by pulling on the white end of the microphone cable.

25. Lift the left tweeter up to expose the connected cables at the top and bottom of the left tweeter.
26. Pinch down on the metal tab and pull outward to disconnect each cable.
27. Lift the left tweeter up and out of the case.