Doss E-GO II Charging Port Replacement

ID: 186087

Description: Use this guide to check and replace the...

Steps:

1. Peel the backing off of the speaker.
2. Remove eight 7.9 mm screws using the Phillips #00 screwdriver.
3. Gently pull apart the grille on the sides of the speaker.

4. Remove four 7.8 mm screws using the Phillips #00 screwdriver.
5. Pull out the charging port and remove the two 7.8 mm screws using the Phillips #00 screwdriver.
6. Apply a bead of flux.

7. Press the soldering iron tip firmly to melt the solder.
8. If you heat the area for more than 10 seconds, the excessive heat may damage the board, port, and wires.
9. Use tweezers to remove the charging port.