Framework Laptop 12 Webcam Replacement

ID: 186400

Description: Follow this guide to remove and replace the...

Before you begin repairs, unplug your laptop and shut it down from the operating system. This ensures that the laptop isn't in standby/suspend mode.
The indicator LEDs along the edges should be unlit. The laptop should be silent.
If you accidentally turn on the laptop during repair, hold the power button down for 10 seconds to shut it down.
Make sure your Framework Screwdriver has the T5 Torx bit (labeled as T-5) facing outwards. If it's not, pull the bit out and flip it.

Open the laptop lid so that both the screen and the base lie flat on your work surface.

The Display Cover is held in place with magnets along the top edge and clips along the remaining edges.
Use the flat end of your Framework Screwdriver to pry up the right edge of the Display Cover.

Slide your fingers under the top edge of the Display Cover to release it from the laptop.

Use your Framework Screwdriver to remove the four 3.3 mm‑long T5 Torx screws securing the display to the Top Cover.
These screws are not captive. Store them in a safe location for reassembly.

Insert the bit end of your Framework Screwdriver into the small hole on the display, below the Framework logo.
Slide the display down towards the hinge edge to release the tabs holding the top edge of the display in place.

Use your fingers to carefully swing the display over so it lies on top of the keyboard.

Use your Framework Screwdriver to remove the two 3.3 mm‑long T5 Torx screws securing the webcam bracket on the top edge behind the display.
These screws are not captive. Store them in a safe location for reassembly.

Use the flat end of your Framework Screwdriver to lift the webcam out of its recess.
Avoid touching the black camera module near the center of the webcam.
Flip the webcam over and gently hold it down with your fingers.

Use the flat end of your Framework Screwdriver or a fingernail to gently pry up the locking tab on the webcam cable ZIF connector.

Congratulations on completing disassembly! The remaining steps will show how to reassemble your Framework Laptop.

Peel off any protective liners covering the camera lens on the replacement webcam.
Carefully look over the part and peel off any remaining liners. The liners are normally clear or colored plastic films that easily detach.

Bend an inch (2.5 cm) of the webcam cable over so that the shiny side is facing you.
Slide the webcam cable into the ZIF connector up to the printed line on the cable.
Use your finger to flip down and gently press the locking tab in place.

Align the webcam bracket to the Top Cover and lay it in place.
Make sure the tabs on the top edge of the webcam bracket sit in their slots on the top edge of the display.

Use your Framework Screwdriver to install the two 3.3 mm‑long T5 Torx screws to secure the webcam.

Use your fingers to carefully swing the display over so it lies on top of the Top Cover.

Align the display in the Top Cover such that the top edge of the display is slightly below the top edge of the Top Cover.
Use your fingers to slide the display upwards to latch the tabs on the top edge of the display.
The top edge shouldn't have any gaps when the display's in place.

Use your Framework Screwdriver to install the four 3.3 mm‑long T5 Torx screws to secure the display to the Top Cover.
Tighten the screws until they're snug. Don't over-tighten them, or you may damage the screw tabs.

Use your finger to press along the length of the Display Cover to snap it onto the laptop.
Make sure all the clips along the left, top, and right edges are fully seated.

Back