Logitech G915 X Lightspeed Battery Replacement

ID: 190582

Description: Follow this guide to replace a worn-out or dead...

Steps:

1. Slide the power switch on the top edge of the keyboard to the OFF position.
2. A red indicator should be visible beneath the switch.
3. Unplug all cables from your keyboard.
4. Lay your keyboard down with the feet facing up on a clean work surface.
5. If your work surface might scratch the keyboard, place a soft towel under it.

6. The Logitech sticker hides two battery cover screws.
7. Heat an iOpener and lay it on the Logitech sticker for one minute.
8. Alternatively, you can use a hair dryer to heat the sticker. Make sure it's on the Low setting to avoid warping the plastic.

9. You can either peel up the bottom corners of the sticker until you can access the screws, or you can remove the sticker entirely.
10. Use an opening tool, spudger, or your fingernail to peel up a corner of the sticker until you can grip it with your fingers.
11. Peel up the sticker with your fingers and remove it.

12. Use a Phillips screwdriver to remove the two 4 mm‑long screws securing the battery cover.

13. Strong plastic clips secure the battery cover to your keyboard.
14. Insert an opening tool into the seam between the battery cover and the rear edge of your keyboard.
15. Slide your opening tool along the rear edge to release the clips securing the battery cover.

16. Don't try to fully remove the cover yet, as it's still connected by the battery cable.
17. Gently reposition the cover so you can access the battery connector.

18. Use a pair of angled tweezers to firmly grip the battery connector.
19. Hold the tweezers with your fingers as close to the connector as possible to get a firm grip.
20. Gently rock the connector side‑to‑side and slide it straight out of the socket.

21. Remove the battery cover.
22. Congratulations on completing disassembly! The remaining steps will show you how to install your replacement battery and reassemble your device.

23. Light adhesive secures the battery to its cover.
24. Gently slide the flat end of a spudger under one of the short edges of the battery and lift to separate the adhesive.
25. Be very careful not to puncture the battery, as it can leak dangerous chemicals or catch fire.
26. Remove the battery from its cover.

27. Cut a piece of double-sided tape so it fits on the line of squares on the bottom of the battery cover.
28. Press the tape firmly into place on the row of squares and remove the liner.

29. Lay your new battery into its recess in the keyboard so the cable is on the left edge, near the battery connector.

30. Insert the new battery's connector into its socket so the side with exposed pins is on the bottom.
31. Use a spudger to push the battery connector fully into its socket.
32. Press only on the connector itself, and not on the wires.

33. Set the battery cover into place and press down firmly along the rear edge to engage the clips.
34. You should feel and hear "clicks" as the clips engage.

35. Use a Phillips screwdriver to install the two 4 mm‑long screws securing the battery cover.

36. Use your fingers to apply the sticker to the battery cover.
37. To help the sticker adhere better, you can apply some heat with an iOpener or hair dryer.