(New) iPhone 15 Microphone Installation

ID: 191778

Description:

Steps:

1. Use tweezers or your fingers to remove the old adhesive from the bottom of the frame.
2. If there's adhesive residue on the frame, use high concentration isopropyl alcohol (greater than 90%) and a coffee filter or lint-free cloth to clean it.

3. If your microphone comes with adhesive installed, skip the next two steps.
4. While holding the microphone adhesive with one hand, use your fingers or a pair of tweezers to remove the white liner from the adhesive.

5. Hold the microphone so the metal side is facing up.
6. Apply the adhesive to the microphone with the pull tab pointing up.

7. Remove the blue liner from the microphone adhesive.

8. Insert the microphone at a downward angle so the adhesive adheres firmly to the frame around the sound channel.
9. Press the microphone firmly into place.

10. Use a tri-point Y000 driver to install the 1.3 mm screw securing the grounding clip and microphone.
11. Use a Phillips #000 driver to install the 1.3 mm screw securing the bottom right of the microphone.
12. Use a standoff driver to install the two 3 mm standoff screws securing top of the microphone.
13. If you don't have a standoff driver, you may use a thin flathead driver—but be careful not to strip the shallow notches in the screw heads.

14. Use the flat end of a spudger or your finger to connect the microphone press connector.