How to Repair a Broken Pool Cue
ID: 199158
Description: This guide will show you how to fix the butt of...
Steps:
- Clean both broken surfaces to remove any dust, splinters, or old glue.
- If the cue stick is chipped or uneven, use 80–100 grit sandpaper to lightly sand the area and smooth the surface out before continuing.
- Apply a thin, even layer of wood glue to one of the broken surfaces.
- Spread the glue using something small and disposable, such as a brush, old gift card, cotton ball, or your finger.
- Avoid spreading glue with paper towels or cloth, fibers can get stuck in the adhesive.
- Fit the broken pieces together tightly.
- Apply firm but controlled pressure so the joint seats fully without shifting.
- Make sure the pieces are perfectly straight before the glue begins to set. A crooked joint is difficult to fix once the glue dries.
- Use a cloth or cotton pad to gently wipe away any glue squeezing out from the seam.
- Hold the two pieces together with steady, even pressure for about 20 minutes, or until the glue begins to set.
- You may also use clamps to keep the cue aligned—just make sure the pressure is even.
- Be sure all excess glue is removed before holding or clamping the cue. Dried glue on the cue’s finish is very difficult to remove.
- Place the cue stick in a safe location and let the glue to dry fully based on the manufacturer’s instructions.
- Do not lean the cue against a wall. This can cause the joint to shift and dry crooked.
- Choose a spot where the cue will not be bumped or handled. Keep it away from pets, children, or anything that may cause movement.
- If the repaired area feels rough or has visible dried glue, lightly sand it before polishing.
- Use a clean rag to polish the repaired area and blend it with the rest of the cue. Rub in small, even motions until the finish looks smooth and consistent.
- Wipe down the entire cue with the rag one final time to remove any excess oil and reveal the restored finish.
