Garmin Drive 50 LM Battery Replacement

ID: 199428

Description: If you're having battery problems with your...

Steps:

1. Use a T5 Torx screwdriver to remove the four 9 mm-long screws securing the case.

2. Insert an opening tool into the seam between the case and the chassis.
3. Pry around the perimeter of the device until the case releases.
4. It is recommended to work along the length of the device first, then the width.

5. Once open, set the screen down at an offset to be able to see the yellow cable.

6. With tweezers, flip up the brown locking flap to release the ribbon cable.
7. Gently disconnect the yellow ribbon cable.

8. Locate the two white plugs on the side of the mother board.
9. With your tweezers, gently pull on the most right plug until it disconnected from the mother board.
10. The battery might be slightly sticky due to adhesive that was holding it down.