Google Pixel 10 Pro Battery Installation

ID: 199553

Description:

Steps:

1. Before installing a new battery, check the recess for leftover bits of plastic, as well as adhesive residue from the battery sleeve.
2. If the battery came out cleanly, you can skip this step.
3. Remove any bits of plastic from the old battery sleeve.
4. Use one or two drops high‑concentration (>90%) isopropyl alcohol and a microfiber or lint‑free cloth to clean up any adhesive residue.
5. Be careful not to get alcohol in the cutouts in the battery recess—the bottom of the screen is exposed and may get damaged.
6. Allow the alcohol to dry completely before continuing.

7. Remove the large, colored liner from the battery to expose the adhesive.

8. Hold the battery above its recess and use your finger to push down and reconnect the battery press connector.
9. Temporarily reconnecting the battery ensures that it's sitting properly in its recess.
10. Lay the battery into its recess and press down firmly to secure it.

11. Use a spudger to pry up and disconnect the battery.

12. Use your fingers to remove any remaining stickers or liners from the battery.

13. Lay the interconnect cable back in place, making sure the connectors line up with their sockets.

14. Use your finger to press down and connect the both interconnect cable press connectors.

15. Put the lower interconnect cable cover back into place, sliding the tabs on the top corners under their hooks.

16. Use a Torx Plus 3IP screwdriver to install the two 5.0 mm‑long screws securing the lower interconnect cable cover.

17. Put the upper interconnect cable cover back into place, sliding the tab on the left side into its slot.

18. Use a Torx Plus 3IP screwdriver to install the 5.8 mm‑long screw securing the upper interconnect cable cover.