Garmin Drive 61 LM Motherboard Replacement

ID: 200143

Description: If your Garmin drive LM 61 freezes or refuse to...

Steps:

1. Place the device screen side down with the back screws facing up towards the ceiling.
2. Remove the four T5 Torx screws on the rear case.

3. Insert an opening tool into the seam between the rear case and screen.
4. Pry around the perimeter.
5. Pull the rear case and screen apart, with care not to strain the attached ribbon cable.
6. Set the screen next to the rear case.

7. Use a T5 Torx screwdriver to remove the five screws securing the motherboard.

8. Be gentle when removing as these are more delicate parts of your device.
9. Use an opening tool to dislodge the speaker and battery.

10. Flip the motherboard upside down and use your fingernails to disconnect the battery connector.

11. Stick the new battery and speaker back onto the plastic.
12. Reconnect the speaker and battery.

13. Disconnect the screen ribbon cable.
14. Carefully extract the motherboard from the device.

15. Place new motherboard into device and reconnect wire.