ThermoPro TP50 Digital Hygrometer Indoor Thermometer Fixing Cut Wires

ID: 200210

Description: This guide is meant to teach how to repair cut...

Steps:

1. Turn the ThermoPro TP50 over, so that the screen faces down.
2. Remove the battery cover.
3. Remove the battery.

4. Use a Phillips screwdriver to remove the screws in each corner of the back.

5. Remove the back cover of the ThermoPro TP50.
6. Be careful during this step, as the wires inside can break.

7. Using a Phillips screwdriver, remove the five screws holding down the circuit board.
8. When the screws are removed, grab the circuit board and lift it off the device.

9. Grab the wire that needs to be soldered.

10. Use a wire stripper to remove the insulation of the wire.
11. Make sure to only remove a small portion of the insulation at the end of the wire. This will ensure the wire is still long enough to be soldered.

12. When the solder is hot, place it over the wire and metal prong.
13. Do not hold the solder over the wire and prong for too long, as you can melt the metal.
14. Be careful using this tool, as it can lead to burns or injury.