HP ProBook 455 G7 RAM Replacement

ID: 200235

Description: This guide explains how to replace or upgrade...

Steps:

  1. Before beginning, completely power off the laptop and unplug the charger and any peripheries.
  2. Flip the laptop over so the lower case is facing up.
  3. Use a Phillips #1 screwdriver to remove the seven 8 mm-long screws securing the lower case.
    4. Step image
  4. Insert an opening tool into the seam between the lower case and chassis.
  5. Pry around the entire perimeter until the lower case fully releases.
  6. Lift and remove the lower case.
    7. Step image Step image Step image
  7. Use a Phillips #1 screwdriver to remove the three 4 mm-long screws securing the battery.
  8. Carefully lift the battery and remove it from the laptop.
    9. Step image Step image Step image
  9. Two clips secure the RAM module in place, one on each side. Using your fingers, spread the clips away from the RAM module.
    10. Step image
  10. The RAM stick should pop up at an angle.
    11. Step image
  11. Carefully pull the module directly out of its socket.
  12. Align the notch on the new RAM module with the slot in the connector.
  13. Slide the module in at an angle, then press down until it clicks into place.
  14. The HP ProBook 455 G7 typically supports DDR4 SO-DIMM RAM up to 32 GB (2 × 16 GB). Make sure both sticks are properly seated before reassembling.
    15. Step image
Back