Nextbase 320XR Battery Replacement

ID: 206049

Description: This is a step-by-step guide to replace the...

Steps:

1. Remove the microSD card before starting to disassemble.
2. Remove the 4 #00 screws.

3. With the Spudger carefully pry apart the case, as cables inside are very short.

4. Remove the display cable from the connector.

5. Remove the 4 #00 screws.

6. Remove the Click&Go PRO mount cable from the connector.

7. The battery is held in place with a sticky pad, carefully use the Spudger to separate the battery from the board.
8. Carefully unsolder the 3 battery wires from the board.

9. Carefully solder the 3 battery wires in the same order as the old battery.
10. Place the battery on the sticky pad to hold in place.

11. Use the Precision Tweezers to place the Click&Go PRO mount cable back into the connector.
12. Use the Precision Tweezers to place the mic back into it's holder.