iPhone 17 Pro Taptic Engine Installation

ID: 207262

Description:

Steps:

  1. Place the Taptic Engine upside down on the edge of the iPhone frame.
  2. While holding the Taptic Engine with one hand, use your finger to press and connect the Taptic Engine press connector.
    3. Step image
  3. Flip the Taptic Engine over the frame and align it using its screw holes.
  4. The Taptic Engine flex cable should fold neatly between the Taptic Engine and the frame.
    5. Step image Step image Step image
  5. Use a standoff screwdriver to install the two 4.0 mm‑long Taptic Engine screws.
    6. Step image
  6. Use your fingers or a spudger to fold the flex antenna down in place.
    7. Step image Step image
  7. Use a JIS 00 screwdriver to install the three 2.0 mm‑long flex antenna screws.
    8. Step image
  8. Use tweezers to carefully place the ground clip in place.
  9. Be sure to orient this clip correctly as shown in the images.
    10. Step image Step image
  10. Use a JIS 00 screwdriver to install the two 2.0 mm‑long ground clip screws.
    11. Step image
Back