HP ProBook 450 G6 Touchpad Assembly Replacement

ID: 212759

Description: The touchpad assembly replacement of HP ProBook...

Steps:

1. Power off your laptop and disconnect the charger and any peripheries before beginning disassembly.
2. Loosen the five captive Phillips 8.2 mm screws securing the lower case.
3. Remove the two 5 mm Phillips screws securing the lower case.

4. Insert an opening pick into the seam between the lower case and chassis.
5. Slide the opening pick around the entire perimeter, while prying every couple of centimeters to release the retaining clips.
6. Remove the lower case.

7. Remove the three Phillips M2.0x4.0 screws that are securing the battery.

8. Rotate the top of the battery up and lift the battery out of the Probook.

9. Flip up the black locking flap securing the touchpad ribbon cable.
10. Disconnect the touchpad ribbon cable.

11. Remove the six M2.0x2.0 Phillips screws securing the touchpad.

12. Lift and remove the touchpad.
13. Lift/remove any silver type securing the touchpad as needed.