HP ProBook 440 G6 RAM Replacement

ID: 213586

Description: Do you need to inspect or replace your RAM? In ...

Steps:

1. Using a Phillips #0 Screwdriver, remove the two 5 mm screws on the front-facing side of the lower case.
2. Using a Phillips #0 Screwdriver, remove the remaining five 5 mm Phillips screws securing the lower case.
3. The two screws in the front of the backplate are of a differing size to the other five.

4. Starting under the display, carefully use a plastic prying tool (iFixit opening tool) to disengage the retaining clips.
5. You may hear soft clicking sounds as the clips come undone.
6. Once a corner or edge starts to lift, slowly slide the tool along the edge to loosen more of the bottom panel.
7. Keep working around the edges until all the clips are loose.

8. Gently lift the rear of the cover to disengage it from the computer.
9. Carefully remove the bottom cover from the computer.

10. Using a Phillips #0 Screwdriver, remove the two 4mm Phillips screws that secure the battery to the computer.

11. Use a tool to push the tab back on the bottom left of the battery.

12. Lift the top of the battery.
13. Lift the battery out of the computer.

14. Carefully fold metallic sheet down to reveal the Ram.

15. Spread the retaining tabs on each side of the memory module slot to release the memory module.
16. The Ram should spring up on the end opposite the metallic sheet. If it doesn't, carefully pry up on the side opposite the metallic sheet.

17. Carefully pull the RAM at an angle to remove it from its connector.
18. Memory modules are designed with a notch to prevent incorrect insertion into the memory module slot.