How to Fix the Bosch Washing Machine F34 Error Code
ID: 218141
Description: [youtubevideo|zxPV_7W_980]The Bosch F34 error...
Steps:
- Stop and check the water level through the door glass before trying to release the door.
- Hot water may be in the drum if the washer stopped mid-cycle, so let it cool before draining or opening the door.
- Don't try to open the door if the water level is above the glass, as hot water can spill out and burn you.
- Unplug the washer or switch it off at the power supply before draining water, opening the service flap, or using a manual release.
- Keep the washer powered only while trying the control panel child lock check.
- Drain the washer before releasing the door if there is lots of water in the drum or the water level is above the glass.
- Open the lower-right service flap on the front of the washer.
- Unclip the drainage hose, aim it into a tray, and remove the hose cap.
- Have extra trays ready, because one tray may not hold enough water if the drum is full.
- Refit the hose cap to stop the flow when the tray fills, empty the tray, and repeat until the excess water is drained.
- Refit the hose cap and clip the drainage hose back into place.
- Check whether the child lock is active if the wash program has finished but the door still won't open.
- On this Bosch Serie 4 design, switching the washer off doesn't necessarily deactivate the door lock.
- Hold the two child lock buttons on the control panel for three seconds.
- Wait for the washer to beep and for the door latch to deactivate.
- Try opening the door gently after the latch releases.
- Switch the washer off at the power supply and leave it off for about 15 minutes.
- This may reset the washer and allow the door lock to release.
- Restore power if needed and try opening the door gently.
- Make sure the washer is switched off and the water level is below the door glass before using the emergency release.
- Open the lower-right service flap on the front of the washer.
- Find the emergency door release just above the filter.
- Use a flat-blade screwdriver to push into the release mechanism and pull the release down.
- Listen for the door catch to click open, then try opening the door gently.
- Close the service flap when you're done.
- Suspect a faulty door release mechanism if the child lock check, power supply reset, and emergency release don't open the door.
- Suspect a faulty handle or locking mechanism if the door keeps getting stuck after you get it open.
- On Bosch Serie 4 machines with this latch design, there isn't a practical front-access way to unclick the latch.
- Stop pulling hard on the handle if it won't release the latch, as forcing it can break the handle or door trim.
- Try these release tricks only on Bosch models with a latch shape that can be caught from the door seam.
- Slide an old credit card into the seam near the latch and wiggle it to try to catch and release the door latch.
- Work a piece of string into the groove around the door, wrap it around the door, and pull it to try to catch the release mechanism.
- Stop if the door trim, glass, or rubber seal starts to bend or lift.
- Call a washing machine technician if the standard release methods don't open the door.
- As an absolute last resort, a large screwdriver can be wedged between the door and cabinet to force the door open.
- This method isn't advised because it can damage the door, cabinet, gasket, or lock, and the tool can slip and injure you.
- Don't force the door open while water remains in the drum.
- Remove the laundry after the door opens and check that the door opens and closes normally.
- Leave the dispenser drawer slightly ajar after wash cycles.
- Leave the drum door open after wash cycles to improve ventilation and reduce smells.