How to Fix the Indesit Washing Machine F06 Error Code

ID: 218509

Description: [youtubevideo|RCnxTPkQJ90]The F06 error on...

Steps:

  1. Switch off the washer and unplug it before touching the lower panel, filter area, or door lock area.
  2. Stop using the washer if you smell burning electrical insulation or sulfur, and leave it unplugged until it has been inspected.
  3. Don't force the door open if the drum is full of water or the water is hot.
  4. The F06 error on these models indicates the door is stuck shut and won't release normally.
  5. Switch the washer off at the actual plug socket.
  6. Leave the power off for five minutes.
  7. Try to open the door normally after the wait time has passed.
  8. This reset may release the door lock without any tools.
  9. Use the end of a spoon or a flat blade screwdriver to pop off the lower front panel.
  10. Look on the right-hand side near the filter for the green emergency release cord.
  11. Keep the washer unplugged while the lower panel is removed.
  12. Pull the green cord downward to release the door lock.
  13. Listen for the door lock to release.
  14. If the door stays stuck, pull the cord up and down with a firm grip until the lock releases.
  15. Pull the green cord down with one hand while trying to open the door with the other hand.
  16. Use pliers to grip the cord if your fingers can't get enough leverage.
  17. Don't crush or tear the cord with the pliers.
  18. Inspect the door handle and locking lever after the door opens.
  19. A handle or lever that looks broken may need a separate replacement repair.
  20. Pull the green cord and watch the lock mechanism move up and down.
  21. If the handle and lever look good but the lock won't release, suspect a fault inside the door lock or control system.
  22. Use an old plastic card, not a real credit card.
  23. Slide the card into the gap near the door latch.
  24. Push the card against the latch area to try to release the locking mechanism.
  25. This method may not work on every washer, but it can release some stuck latches.
  26. Feed a piece of string or garden cord into the groove around the door.
  27. Use a flat blade screwdriver to push the cord into the groove if needed.
  28. Hold the cord at the top and bottom of the door.
  29. Pull the cord toward the left-hand side to catch the locking lever and release the door.
  30. This method may work on some washers even if the card method fails.
  31. Use a large screwdriver to wedge the door open only if the washer is being scrapped or you accept the risk of damage.
  32. Wear work gloves and keep your hands clear of the latch area while prying.
  33. Expect this method to damage the door, latch, cabinet, or lock parts.
  34. Don't use this method on a washer you plan to repair unless all safer release methods have failed.
  35. Check whether the washer still reports the door as locked after the door is open and the power is restored.
  36. A washer that still thinks the open door is locked has a definite fault in the lock or control system.
  37. Replace a broken handle or lever if that is the only visible fault.
  38. Get professional diagnosis if there was a burning electrical or sulfur smell, or if the lock fault remains after opening the door.
  39. Consider replacing the washer if it is old, has electrical burning smells, or would need repeated call-outs and repairs.
Back