Toyota Camry 2008 Side Mirror Replacement

ID: 219909

Description: If your Toyota Camry 2008 Side Mirror is...

Steps:

1. Remove the trim piece from the inside of the door.
2. The trim piece should be easy to pull off without too much pressure. If you struggle, you may use another item to gently pry it off.

3. Remove the connector by pushing the tab in and then pulling out the connector.
4. You can use an additional tool to help push the tab in if you can't push it in with your fingers.
5. Be careful to not pull on the wires; pull at the base to prevent damaging the connector.

6. With a 10mm socket wrench, remove the three nuts.
7. As you are removing the nuts, the mirror becomes loosened. Make sure you are holding onto the mirror to prevent it from falling.

8. Remove the side mirror.
9. Hold it with a good grip as you pull it away from the car door to prevent the sockets from getting loose.

10. Place the new mirror and line it up.
11. Make sure that the mirror is correctly aligned to the correct holes to properly install it.

12. Place the nuts with the 10mm socket wrench and tighten.
13. Hold the mirror firmly until you have ensured that all nuts have been properly tightened.

14. Reinstall the connector
15. Push in the connector until you hear a click to confirm that it is properly secured.

16. Put the trim piece back on.
17. Make sure the trim is secured to the car door so it does not fall off.

18. Test the connection with buttons.
19. Make sure that the button is switched to the side that is being tested and it's moving in the correct direction.