BT2500 Bluetooth Speaker Battery Replacement

ID: 220405

Description: Before you begin, it is recommended to drain...

Steps:

  1. Remove the rear cover by inserting a thin tool; it is simply clipped in place.
    2. Step image
  2. Remove all screws
    3. Step image
  3. Gently open it, separating the frame from the bottom of the front grille. Be careful not to cut the volume knob wire.
    4. Step image
  4. Remove the screw from the motherboard; it should then be able to move slightly.
  5. Remove the 3-position side button labeled: "OFF, Bluetooth, line". You can simply pull out the outer plastic that is clipped onto the connector. This plastic blocks the motherboard, and you cannot lift the motherboard because of it.
    6. Step image Step image
  6. Now that the screw and the button securing the motherboard are removed, it can move.
  7. Lift the speaker. You can disconnect it if necessary. You can see the battery underneath (arrow). Disconnect its connector by pulling gently (it attaches to 2 pins).
  8. Lift the motherboard from the side opposite the obstructing components (USB port and microphone) to access the battery.
  9. The battery is held in place with a bit of adhesive; remove it.
  10. Place the new battery in its place. Then, reconnect everything.
  11. Test to ensure it works before reassembling everything in reverse order.
    12. Step image Step image
Back