GE Glass Stovetop Replacement

ID: 221222

Description: [youtubevideo|aszWYRdrph8]Use this guide to...

Steps:

1. Check the model number label in the lower compartment before ordering the replacement glass stovetop.
2. This guide was written for GE stove model JBS60DK4BB, and similar models may use different parts or hardware.
3. Let the cooktop cool completely.
4. Unplug the stove, or switch off the breaker if the plug isn't reachable.
5. Wear cut-resistant gloves and safety glasses when handling cracked glass.
6. Use a screwdriver to remove the two screws that secure the glass stovetop to the frame.
7. Keep the screws for reassembly.
8. Lift the front of the glass stovetop so it hinges up from the back.
9. Support the glass while you work underneath it.
10. Don't pull the glass away from the stove yet, because the burners and wires are still attached underneath.
11. Start at the rear of the cooktop and detach the hot surface light from the underside of the glass.
12. Release the retaining tabs or clips on one side of a burner.
13. Slide the other side of the burner out of its mount.
14. Repeat for every burner still attached to the old glass.
15. Be careful with the temperature sensor that runs across the middle of the burners, because it can break.
16. At the rear of the cooktop, remove any wire retainers attached to the glass.
17. Use a screwdriver to remove the ground screw from the old glass top.
18. Note where each retainer and the ground screw were attached.
19. Lift the old glass stovetop off the hinges once every component is detached.
20. Keep cracked glass level and supported so loose shards do not fall.
21. Compare the old glass stovetop with the new one before moving any hardware.
22. Move each retaining clip to the matching location on the new glass.
23. Check the old glass again to make sure no clips were left behind.
24. Set the new glass stovetop onto the rear hinges.
25. Confirm the new glass sits correctly before reattaching the burners.
26. Work from the back toward the front as you reinstall the parts.
27. Use a screwdriver to reinstall the ground screw and any rear wire retainers.
28. Slide one side of a burner into its retaining clip.
29. Align the opposite tab or clip with the matching hole in the new glass.
30. Press the tab into place until the burner locks in.
31. Wiggle the burner gently if the tab doesn't drop into the slot.
32. Don't bend, pinch, or force the temperature sensor while positioning the burners.
33. Reattach all retaining clips that keep the wires out of the way.
34. Route the wires along their original paths, away from the burner surfaces and glass edges.
35. Reattach the hot surface light.
36. Check that no wires are loose, pinched, or trapped where the stovetop will close.
37. If you're replacing a burner at the same time, move each wire to the matching terminal on the new burner before clipping it in.
38. Lower the glass stovetop onto the frame while making sure the wires stay clear.
39. Use a screwdriver to reinstall the two screws that hold the glass stovetop in place.
40. Plug the stove back in or switch the breaker on.
41. Test the burners and the hot surface light.
42. Disconnect power immediately if you see sparks, smell burning, or find a burner that doesn't work correctly.