Brother PT-D200 Circuit Board Replacement

ID: 22895

Description:

Steps:

1. Gently pull out the ribbon cable from the circuit board.
2. The ribbon cable is very fragile.

3. Remove two-pin plastic connector from the circuit board.
4. Gently pull the two-pin connector from the circuit board to avoid damaging the board.

5. Remove the two 3/16" screws from the circuit board using the Helping Hand 1/4" screwdriver.

6. Release the two black clips that hold the LCD cable ribbon in place. To release, pull the clips towards the ribbon.

7. Disconnect the LCD ribbon cable from the circuit board.