Opening the iron, inspecting the electronics

ID: 237750

Description:

Steps:

1. Unplug the device and let it cool down. Failure to do so poses a risk of injury or death!
2. Use a pointed object to remove the rubber plug from the hole
3. Remove the PH2 screw (see image for length)

4. Carefully remove the "Calc clean" button with a thin flathead screwdriver by prying it up from the side.
5. Remove the PH2 screw under the button (see photo for length).

6. Open the clips on the bottom of the iron
7. Carefully pry up the rear cover
8. Tilt the handle cover forward, release the marked tabs

9. If only the electronics in the handle need to be repaired, these steps can be skipped.
10. Remove the knob using a flathead screwdriver or spudger.
11. Release the two PH2 screws (see image for length).
12. Release the two PH2 screws (see image for length).
13. The heating plate can now be removed.