milwaukee m18 FTR Compact Router ROTOR ASSEMBLY change

ID: 238316

Description: milwaukee m18 FTR Compact Router ROTOR ASSEMBLY...

Steps:

  1. Remove the collet (32) and pull out the low bearing assembly (29).
  2. If you do not have the proper tools, use the attached file to 3D print them. A 3D-printed part and a 3 mm pin are required.
  3. After pulling out the low bearing assembly, you must remove the hex nut (30) holding the rotor center. A 19 mm hex and a power tool are recommended.
    4. Step image Step image
  4. Remove the screws from the main body. (25)(26) These are Torx T15 and T20.
  5. Disassemble it and remove the motor support ring (73). You must pull it upward. It can be a bit tricky...
    6. Step image
  6. Pull the protruding black plastic piece upward like a handle to remove it from the metal case. The motor housing (71) and rotor (72) will come out together.
    7. Step image
  7. Remove the damaged rotor and replace it with a new one.
    8. Step image
Back