Uniden TCX905 Back Shell Replacement

ID: 24019

Description: The TCX905 consists of a two part shell. The...

Steps:

1. Starting from the top of the cover, slide down and away from the phone with your thumb
2. Lift battery cover off of batter and place it to the side

3. Once battery cover is removed, place your thumb and index fingers on the the wires near the receptacle
4. Gently pull straight up on the wires until a click is heard which signifies the battery is completely disconnected
5. Place battery pack to the side

6. Remove the two 11mm screws inside the battery storage compartment using Phillips #1 screwdriver (located near the very bottom of the phone)

7. Gently open phone casing along the seam at the bottom of the phone using index and middle fingers of both hands

8. Ensure that wired connection between circuit board and back shell is not strained
9. Fold the back shell underneath the front shell and circuit board