Uniden TCX905 Back Speaker Replacement

ID: 24022

Description: The back speaker is where the ring of the phone...

Steps:

1. Starting from the top of the cover, slide down and away from the phone with your thumb
2. Lift battery cover off of batter and place it to the side

3. Once battery cover is removed, place your thumb and index fingers on the the wires near the receptacle
4. Gently pull straight up on the wires until a click is heard which signifies the battery is completely disconnected
5. Place battery pack to the side

6. Remove the two 11mm screws inside the battery storage compartment using Phillips #1 screwdriver (located near the very bottom of the phone)

7. Gently open phone casing along the seam at the bottom of the phone using index and middle fingers of both hands

8. Ensure that wired connection between circuit board and back shell is not strained
9. Fold the back shell underneath the front shell and circuit board

10. Lay the back shell with the inside facing up
11. To remove the speaker guard, first remove the 7mm screw from inside the back shell

12. To access the speaker, flip the back shell over and use a plastic opening tool to pop open the black cover
13. Gently push the speaker guard out of place with your thumb
14. Carefully slide the speaker out from its setting and place speaker guard aside

15. With speaker exposed, remove the speaker by cutting the red and black wires near their contact location