Uniden TCX905 Button Keypad Cleaning Guide

ID: 24023

Description: If problems occur with the button keypad, this...

Steps:

1. Starting from the top of the cover, slide down and away from the phone with your thumb
2. Lift battery cover off of batter and place it to the side

3. Once battery cover is removed, place your thumb and index fingers on the the wires near the receptacle
4. Gently pull straight up on the wires until a click is heard which signifies the battery is completely disconnected
5. Place battery pack to the side

6. Remove the two 11mm screws inside the battery storage compartment using Phillips #1 screwdriver (located near the very bottom of the phone)

7. Gently open phone casing along the seam at the bottom of the phone using index and middle fingers of both hands

8. Ensure that wired connection between circuit board and back shell is not strained
9. Fold the back shell underneath the front shell and circuit board

10. Carefully remove the middle two 7mm screws, the outer top 9mm screws, and the top middle 7 mm screw that hold the logic board to the front shell of the phone casing using the Phillips #1 screwdriver

11. Using index finger and thumb, carefully remove the circuit board from the front shell of phone

12. Remove the white plastic sheet covering the button pad with your fingers
13. Gently remove the silicon button pad

14. Wet one end of the cotton swab with water and clean button pad as needed
15. Repeat process with multiple cotton swabs if needed
16. Dry the button pad with a clean, soft rag before replacing