Testing Patagonia Waders For Leaks

ID: 27703

Description:

Steps:

1. Set up a ladder in a level place outside that you don't mind getting wet.
2. Turn the waders inside out.
3. Clip the waders to the ladder.

4. Put the hose into the waders.
5. Slide the hose into one leg of the waders.

6. Turn on the hose and begin to fill the waders.
7. Be sure to pay attention because the large amount of water may tip the ladder. If needed, weigh the back side of the ladder down to prevent it from tipping.

8. Watch for leaks. When you find a leak, mark it with a permanent marker.
9. Repeat this process for the other leg, marking all the leaks you find.
10. Dump the water out and allow the waders to dry completely before you continue.