Fixing Rockwheel Electric Unicycle Balance Issues

ID: 28300

Description:

Steps:

  1. open the right side of the Rockwheel's case, the side of the power switch. To access the screws, you need to pull the glued rubber protection a little. Once the case is open you'll see the PCB, the motherboard. You'll need to insert a jumper wire in two right holes on the bottom of the PCB.
    2. Step image
  2. Once the trip wire installed, simply switch on the Rockwheel. Be careful, it is very loud!
  3. Wait for one long beep, 4 short beeps, and one long beep again. Then switch off the Rockwheel, remove the jumper wire, close the case, and you're done.
Back