Disassembling Nerf Recon CS-6 Shell

ID: 31947

Description: This is a prerequisite to replacing any other...

Steps:

  1. Skip this step if magazine is already removed.
  2. Pull slide back.
  3. Pull backwards on release buttons and slide magazine out.
  4. Push slide back forward and pull trigger.
    5. Step image
  5. Use the Phillips #0 Screwdriver to remove these 9 screws.
  6. All screws marked in red are 9.6 mm Phillips #0 screws.
  7. Note that left most screw is longer than the rest and is a 18.6 mm Phillips #0 screw.
    8. Step image
  8. Pull slide back to reveal more screws.
  9. Remove these 2 screws.
  10. Push slide forward.
  11. Pull trigger to release compression of the main spring.
  12. Screws are 9.6 mm Phillips #0.
  13. Pulling the trigger will keep spring from launching out of the gun when the two halves are separated.
    14. Step image Step image
  14. Remove the screws on the plunger cap.
  15. Tug the plunger cap off.
  16. Screws are 9.6 mm Phillips #0.
    17. Step image
  17. Remove the 2 screws on the slide.
  18. Screws are 9.6 mm Phillips #0.
  19. Hold the two halves of the gun together to prevent any springs from launching out.
    20. Step image
  20. Pull the gun apart at the middle seam.
  21. Watch for any springs that might launch out.
    22. Step image Step image
Back