Sony Reader Touch Edition PRS-600 Power Button Replacement

ID: 32047

Description: If the power button on the device is faulty or...

Steps:

1. Using the Phillips head screwdriver PH000, remove the two 1.4 mm screws that are located on the backside of the device.

2. Slide the back cover off by pushing it to the left, away from the side that held the screws.
3. Remove the cover.

4. This is what the device should look like once the back cover panel has been removed.

5. Once the back cover has been removed locate the battery in the bottom right corner of the device.
6. Using the pointed end of the spudger, push out the white plug that is connected to the battery from its beige base.

7. Use the flat end of the spudger to pry the battery out of its holder. There may be glue holding it in place.

8. Remove the stylus from the device.

9. Using the Phillips screwdriver remove the 1.4 mm screw from the top panel.
10. Using the same screwdriver, remove the 1.4 mm screw from the back of the device.
11. Pry apart off the top panel of the device.