Cen-Tech Seven Function Digital Multimeter 'On'/'Off' Switch Replacement

ID: 32063

Description: If the 'on'/'off' switch of the device is stuck...

Steps:

1. Place the meter face down, and the back panel and screws can be seen.

2. Unscrew the two 9mm screws on the back panel using a #0 Phillips screwdriver.

3. Remove the back panel of the device by lifting upward.
4. Remove the battery from the meter before continuing.

5. Remove the four 7mm Phillips screws holding the circuit board in place.

6. Gently lift the circuit board away from the device casing.
7. Remove the battery after removing the back cover to reduce the chances of short-circuiting the circuit board.

8. The 'on'/'off' switch is located directly beneath the dial.

9. Gently remove switch from device by lifting upward.
10. Either clean or replace switch.