Ergomixx Blender (Bosch) disassembly

ID: 35395

Description: This guide discusses Bosch blenders from...

Steps:

  1. The speed switch can be removed by placing it on position 3 (to be checked, we broke it without realizing it) and then pulling the switch out.
  2. The 2 first screws are now visible.
    3. Step image
  3. The last 2 screws are hidden under a small plastic cover at the bottom of the motor block.
    4. Step image
  4. In our case, the thermal fuse was blown, i.e. the small white component labelled «Y51 H 120C».
  5. First solution: remove the thermal fuse and place a shunt instead (a small wire). Downside: loss of the thermal protection on this "short working duration" blender.
  6. Second solution: replace the thermal fuse (which is better) by a component with the same characteristics. In this case, probably with a fusing temperature of 120°C and a max. current 5A.
  7. Thanks to Darr and to webpage http://elwo.ru/forum/34-1408-1 for the picture and for giving us the right hint.
    8. Step image
Back