Removing DJI Phantom 2 Vision+ Case Top Shell

ID: 35983

Description: Replacing the top case on your DJI Phantom 2...

Steps:

1. Pinch the top and bottom tabs of the battery case, pull the battery straight out to remove it.
2. The metal connectors form a stiff mechanical connection with the battery, you will need quite a bit of force to remove the battery. Hold the Phantom Vision+ with one hand and remove the battery with the other.

3. Determine if the propellor is clockwise or counter-clockwise rotating.
4. Each arm is labeled with a rotation icon that shows the direction of propellor rotation.
5. If this icon is missing or you can't read it, you can determine the direction of rotation by examining the propellor.
6. A clockwise rotating propellor pushes air down while rotating clockwise, and the opposite is true for a counter-clockwise rotating propellor, and the propellor blade slopes up in the direction of rotation.

7. Loosen a clockwise rotating propeller by holding the motor with one hand and spinning the propellor clockwise.
8. Remove the propellor.

9. Loosen a counter-clockwise rotating propeller by holding the motor with one hand and spinning the propellor counter-clockwise.
10. Remove the propellor.

11. Remove the following screws from the underside of the Phantom:
12. Twelve 2.0 mm hex bolts
13. Four Phillips #00 screws

14. Gently lift up the top shell case.
15. Do not attempt to fully remove the top shell. The GPS cable is still attached to the mainboard, avoid lifting the case too high or you may damage this connection.

16. The GPS cable molex connector is located on the backside of the mainboard, near the battery opening.
17. Pull the GPS connector straight up out of its socket.
18. Lift the top shell case up and remove it from the body of the Phantom.