DeWalt D28110 Power Cord Replacement

ID: 37657

Description: This guide will take you through removing the...

Steps:

1. Using the T-15 screwdriver, remove the four 22-mm torx screws holding the back panel in place.
2. Unplug the grinder before any disassembly.

3. Use the edge of the spudger to loosen and remove the back panel.

4. Remove the single 20-mm torx screw holding the rear panel in place.

5. Pull back the rear side of the back panel.

6. Locate the red switch box.
7. Using the J-10 screwdriver, unscrew the screws and detach the wires.
8. Be sure to remember under which screw the "ground" wire (black) goes.

9. Unthread the two wires from the power cord clamp.