Smart Parts Ion Bolt Replacement

ID: 37862

Description: If the Ion is not shooting properly, the bolt's...

Steps:

  1. Remove the air tank by rotating it counterclockwise.
  2. Do not pull the trigger or jostle the gun, there will still be pressurized air inside the gun that could be expelled and cause bodily harm if injected into eyes and/or skin.
  3. The pressure gauge will indicate the leftover air in the gun.
    4. Step image Step image Step image
  4. Remove the hopper by pulling it out of the feed tube, located on the top of the body. The hopper should easily come off when pulled straight up.
    5. Step image Step image
  5. Turn the gun on by pressing the power button until the red light blinks.
  6. Turn vision mode off by pressing the power button again.
  7. Red light should be flashing in a double blink sequence.
    8. Step image
  8. Pull the trigger to release the air in the gun.
  9. Pressurized air can be forceful, causing particles to be ejected from the gun into your eyes and/or skin. When air bubbles enter the bloodstream, they can block blood vessels, causing embolisms. To avoid this, make sure to point the gun in a safe direction when pulling the trigger because air will be released from the gun.
    10. Step image
  10. Remove the four 8mm screws on each side of the gun's grip using a Phillips #2 screwdriver.
    11. Step image
  11. Remove the grip by sliding it towards the front of the gun.
    12. Step image
  12. Remove the 9V battery by unsnapping it.
    13. Step image Step image
  13. Remove the front and rear 1" screws on the gun's grip frame using a 3/32" Allen Wrench.
    14. Step image Step image Step image
  14. Remove the 12 mm screw on the top of the grip frame using a 3/32" Allen wrench.
    15. Step image Step image
  15. Separate the gun's body from the frame by gently pulling them in opposite directions.
    16. Step image
  16. Remove the 1-1/4" screw that's attached to the blue tube above the front grip using a 3/32" Allen Wrench.
    17. Step image
  17. Gently use tweezers to detach the white vision wire harness, located directly under the feed tube.
  18. Another small tool or your fingers will work for this.
    19. Step image
  19. Remove the two 1-1/4" screws on either side of the circuit board using a 3/32" allen wrench.
    20. Step image
  20. Separate the solenoid from the gun's body by gently pulling it upwards.
    21. Step image
  21. Slide the metal body out of the plastic shell by holding one in each hand and gently pulling apart.
    22. Step image
  22. Separate the front body breach from the fire chamber by rotating the breach counterclockwise.
    23. Step image Step image
  23. Remove the bolt from the front body breach by gently pulling on the bolt.
    24. Step image
Back