Turtle Beach PX22 Microphone Replacement

ID: 40638

Description: If your microphone does not work after...

Steps:

1. Use your fingers to peel off ear cushion by pinching and pulling off the leather.
2. Use a Philips #00 head screwdriver to remove three 7.1 mm screws around the speaker.
3. The housing will come loose.
4. Gently lift the speaker housing off the ear cup, being careful not to pull on the driver/speaker assembly, which is still connected to a board inside.

5. Remove the 7.1 mm screw with a Phillips #2 screwdriver to gain access to the microphone.
6. You may need to pull the wire with the knot out of the way of the screw.

7. Use a soldering iron to carefully desolder the microphone wire connectors from the board.
8. Take care not to overheat the board or nearby components.
9. Insert the new microphone and solder the wires into the correct positions.
10. Replace the screw that secures the microphone with a Phillips #2 screwdriver.
11. Pull the excess microphone wire back into the speaker housing.
12. Hold the microphone neck so that it does not rotate when screwing.

13. Position the speaker on the headset so that the screw holes line up. It should click into place.
14. Use a Phillips #00 screwdriver to secure the three screws.
15. Replace the ear cushion.
16. Use the plastic opening tool to tuck excess leather inside the headset.