Disassembling Kinivo ZX100 Mini Portable Speaker

ID: 40733

Description: Prerequisite only.

Steps:

  1. Open the circular portion at the top of the speaker by twisting it until it reaches the maximum possible height.
  2. Make sure it is twisted fully, as this will allow access to four screws to be removed in the next step.
    3. Step image
  3. Remove the four 12 mm Phillips screws from the enclosure.
    4. Step image Step image
  4. Separate the resonator portion from the base of device to reveal the middle separator of the enclosure. The enclosure will now be in two pieces.
  5. Hold the resonator portion of the enclosure gently aside to make sure there is no tension on the black and red wires coming from the bottom portion of the device.
  6. Excessive force may disconnect the black and red speaker wires from the circuitry in the bottom portion of the device.
    7. Step image Step image
  7. Separate the very bottom portion of the enclosure (marked in red) by pulling vertically on the red portion of the enclosure (marked in orange).
  8. Gently set the very bottom portion and the resonator section aside once they have both been separated.
  9. Remove the circuit board with your hands by lifting and sliding the board away from the LED indicator.
    10. Step image
Back