Android tablet Nobis NB09 Screen Replacement

ID: 40892

Description: This is a guide on how to perform a screen...

Steps:

1. Remove the two 00 Phillips screws located on the right side of the tablet.
2. Use the plastic opening tools to loosen and then pry the back if the tablet off.
3. When prying off the back of the tablet, be careful around the tablets ports. Too much pressure can cause cracks.

4. It is recommended that a grounding bracelet be used in order to avoid damage to the device's circuits through ESD (Electro-Static Discharge)
5. Remove the electrical tape covering the motherboard.
6. Remove the four 4.0 mm T4 Torx screws holding the motherboard to the front half of the tablet.
7. Remove any remaining adhesive tape on the exposed area.
8. Disconnect the ribbon cable attachments by lightly pushing up the locking arm (black tab) on each then gently detaching the pin connectors.

9. Find the notch on the digitzer, located on the left side of the device.
10. Use the Phillips Screwdriver to gently push the notch and lift the digitizer from the screen.

11. Gently slide the digitizer from its clasps to remove it from the screen.
12. The digitizer should now be removed separately from the screen.