Eclipse 180BL Battery Replacement

ID: 49813

Description: Following these easy steps will allow you to...

Steps:

  1. Remove the two screws located on the bottom of the device with a phillips head screw driver.
  2. The two screws can be removed using the PH00 head from the iFixit repair toolkit.
  3. Both screws are 1/8 inch in length.
  4. The bottom cap will come off to reveal the inside main component.
    5. Step image
  5. Remove the main inner component using Spudger, by pushing on the USB port. This will take some force.
  6. Hold on the sides with your fingers, and push to release from the top.
    7. Step image Step image
  7. The plastic LCD cover and the key pad will now be loose; they were held in place by the tension between the case and the internal main component.
  8. Locate the large square pack with a black and red wire coming out of it, this is the battery.
  9. Cut the red and black wires to remove the old battery.
    10. Step image Step image Step image
  10. To Replace, connect the two new lines ( red and black) between the new battery and the device.
  11. You have successfully replaced the battery!
    12. Step image
Back