Magic Bullet MB1001B Casing Replacement

ID: 52099

Description: Are there cracks in your casing? This guide...

Steps:

  1. Use pliers to grip the gear inside of the top of the device.
  2. You may have to remove a sticker that is covering the slit at the center of the bottom before completing the next step.
  3. Insert a flathead screwdriver into the slit at the bottom of the device while still holding the pliers in place gripped on the gear.
  4. Lay the device on its side. Holding the screwdriver stationary to hold the bottom side in place, use the pliers to unscrew the gear by turning the pliers CLOCKWISE.
    5. Step image Step image Step image
  5. Remove the four rubber pegs from the feet on the base of the Magic Bullet using the spudger.
    6. Step image
  6. Remove the four 14.0 mm Phillips head screws in the feet of the base of the Magic Bullet using the Phillips #1 screwdriver.
    7. Step image
  7. Remove the black base plate.
    8. Step image
  8. Remove the two 13.0 mm Phillips head screws from the white plastic cable guide using a Phillips #1 screwdriver.
    9. Step image
  9. Remove the white plastic cable guide.
    10. Step image
  10. Remove the three 11.0 mm Phillips head screws surrounding the white fan blade on the base using the Phillips #1 screwdriver.
    11. Step image
  11. Remove the black base.
    12. Step image
  12. Remove the three white rubber spacers with the spudger.
    13. Step image
  13. Remove the three 11.0 mm Phillips head screws using the Phillips #1 screwdriver.
    14. Step image
  14. Remove the motor.
    15. Step image
Back