Hamilton Beach 51101BA Motor Replacement

ID: 52171

Description: After using this guide you will have learned...

Steps:

1. Remove the container from the blender.
2. Hold the blender and the container, then twist the container in a clockwise motion.
3. Make sure to follow the lock and unlock markings on the container.

4. Turn the blender so the bottom is facing you.
5. Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.

6. Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the motor platform.

7. Unhinge the plastic motor platform from the blender.
8. You may need a plastic spudger to unhinge the motor platform from the blender.

9. Using a spudger, carefully insert the tip into the coil of wire around motor.
10. This is used to hold the rotating piece of the motor still.

11. Remove the white rotor piece by rotating it counter-clockwise.
12. While rotating, make sure the rotating piece of the motor remains still.

13. Move the motor platform to the side.
14. Lift up the motor and remove it from the blender.

15. Some soldering experience required!
16. Desolder the red wire from the green plastic piece.

17. Cut the thin black wire from the wire cap.