HP EliteOne 800 G1 Removing Stand Replacement

ID: 52210

Description: Prerequisite Only

Steps:

1. Press locking latch on the bottom of the base of the stand.
2. Pull the plastic cover off of the stand.

3. Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit.
4. Tilt stand and lift up to remove it.

5. Use a Torx T15 driver to remove the single 10mm screw on the back panel.
6. Pull the back panel toward the bottom of the device to remove it.