HP Envy 23-d060qd TouchSmart Display Assembly Replacement

ID: 52212

Description: As I was moving my computer into another room I...

Steps:

1. Use your hands to unclip the plastic snaps on the back panel of the device.

2. Remove the three 11.5mm PH2 screws from the back panel.
3. The screws will not fall out of the back panel, but they will unscrew to release the back panel.

4. Now, take the back panel off by pulling at it gently with your hands.

5. Use your hands to unclip the plastic bezels for the DVD drive and ports.
6. To unclip the plastic bezels, push the middle of each plastic bezel towards the center of the computer, and then pull them outwards.
7. You may want to lay the computer face down, on a flat, clean surface to ensure nothing falls out when disassembling the computer for next steps.

8. Remove the nineteen 10mm T15 black screws from the edge of the computer.
9. Lay the computer on its front when preforming this step, and leave it face down for the rest of the guide.

10. Lift up the computer by the base very slowly, and disconnect the three wired connections to the display with your hands. Always disconnect wired connections from the plastic base.

11. Set the computer aside, and use a small knife to cut the strips attaching the display to the digitizer.

12. Use a plastic spudger to unclip the 3 ribbon clips on the back of the display.

13. Remove the four 7mm T15 silver screws from the edge of the computer.

14. Gently pull the display free from the digitizer with your hands.

15. Remove the four 17.5mm T15 screws from the speakers.
16. When the speakers are free, use your hands to pull them free from the digitizer.

17. Remove the three 10mm T15 screws from bezel.

18. Use your hands to pull the plastic bezel off of the digitizer.