DeWalt DWD112 Power Cord Replacement

ID: 61431

Description: If your drill has no power, the wires in the...

Steps:

  1. Remove seven TR20 Torx Security screws from the side of the drill.
    2. Step image
  2. Remove the top cover to reveal the inside of the drill.
  3. Set the top cover of the drill aside.
    4. Step image
  4. The power cord and the trigger act as a single part and must be replaced together.
  5. Using one hand grab the trigger box and with the other grab the end of the wire connecting to the trigger box and disconnect the wire.
    6. Step image
  6. Disconnect the second connected wire from the top of the trigger box.
    7. Step image
  7. Lift the trigger box up to reveal the bottom side.
  8. Disconnect the first connected wire from the bottom of the trigger box.
    9. Step image
  9. Disconnect the last wire from the trigger box using the same method from the previous step.
    10. Step image
  10. After all four wires are disconnected, the trigger and power cord are separated from the drill.
  11. The power cord and trigger can be set aside if further disassembly is required.
    12. Step image
Back