Axess SPBT1031 Buttons Replacement

ID: 61587

Description: This guide will be helpful for repairing the...

Steps:

1. Use a metal spudger to remove the mesh speaker covers (the side with the buttons) by wedging the narrow end into the center of the outer edge of the mesh, touching the red plate.

2. Remove the four 5 mm screws from the red panel under the mesh using a Phillips #1 screwdriver.

3. If the screws are difficult to remove, use a pair of tweezers to twist and pick them out.

4. Separate the red interface plate from the black face plate by pulling them apart.

5. Take the red plate and the motherboard and pull apart.

6. Push the set of buttons inward from the outside of the red plate and peel off from the inside.