HP Touchsmart IQ506 Stand Replacement

ID: 66794

Description: Replacing the stand on the HP IQ506. The part...

Steps:

  1. Unplug the power supply from the system.
    2. Step image Step image
  2. Unscrew the RAM door from the system. Use a Phillips #1 screwdriver. Once you do this, unclip it from the bottom and pull forward.
    3. Step image Step image Step image
  3. THIS STEP ONLY APPLIES FOR LEGACY iFixit 54-BIT DRIVER KIT USERS.
  4. When usjng the legacy driver handle, the top hinge screws can be difficult to get to. If you have the legacy 54-bit iFixit driver kit, lock the stand upright and slide it under the stand from the rear to access the top screws. This should be less of an issue with a standalone driver or modern driver kits like the 64-bit/Manta kit.
    5. Step image
  5. Remove the stand from the system. Use a Phillips #1 screwdriver to loosen the 4 screws. The stand will be loose and easily removed.
    6. Step image Step image Step image
Back