HTC Wizard 200 Vibrator Replacement

ID: 6833

Description: Takes you through the steps to install the...

Steps:

1. To expose the battery, remove the outer case with your fingernail.
2. Remove the battery by pulling the black tab.

3. Insert the flat end of the spudger into the two notches on the back of the camera cover and pry them up.

4. Work the spudger around the edges of the camera cover until it comes off.

5. Remove the four 6 mm screws with the T5 Torx screwdriver.
6. One of the screws is under the "void" sticker.

7. Insert the flat end of an iFixit opening tool between the side and inner covers to create a gap.
8. Work the tool around the edges until all the clips release.

9. Once all the clips are open, remove the inner panel from the phone.

10. Use the tweezers to remove the vibrator module.