Macintosh PowerBook 165c RAM and PSRAM Expansion Card Replacement

ID: 7009

Description: The Macintosh 165c can take any any compatible...

Steps:

  1. Orient the computer so the battery is facing you.
  2. Slide the gray plastic battery cover to the right.
    3. Step image
  3. Pull the battery toward yourself until it is fully detached.
    4. Step image
  4. Orient the computer right side up with the rear facing you.
  5. Open the Input/Output (I/O) door.
    6. Step image
  6. Carefully bend the door into an arch until one of the pins releases from its slot.
  7. Once one of the pins is free, remove the I/O door from the computer.
    8. Step image
  8. Orient the computer with the bottom facing up and rear facing you. You should be able to read the Macintosh label in this position.
    9. Step image
  9. Use a T8 torx screwdriver to remove the 6.8mm long screw above and to the right of the modem jack.
  10. Twist counter clockwise to remove the screw.
    11. Step image
  11. Use a T10 torx screwdriver to remove the four, 18mm long screws from the lower case.
    12. Step image
  12. Place your hands on the lower case, just above the I/O panel, and slowly lift the lower case a few inches above the main body of the computer.
  13. Release the large, gray interconnect ribbon cable just behind the I/O panel.
  14. Caution: Lower case cannot be fully removed until two plastic clips in the front corners are released. See the following step for details.
    15. Step image Step image
  15. Place your thumb on the upper case, inside the empty battery slot, and your index finger near your thumb on the left side of the lower case.
  16. Pinch your thumb and index finger towards each other to release the clip. Without releasing pressure on the pinch grip, use your index finger to push the lower case upwards.
  17. Lift the lower case to remove it.
    18. Step image Step image
  18. Locate and lift ram card directly up until connector releases.
  19. Move the card back and forth gently if the connector does not release immediately.
    20. Step image Step image
  20. Locate and lift the PSRAM expansion card vertically until connector releases.
  21. If the PSRAM expansion card is difficult to remove, gently jostle it back and forth as you lift up.
  22. The PSRAM expansion card is an optional component, and may not be included in all devices.
    23. Step image Step image
Back