Bionaire BAP 600 Outer Shell Replacement

ID: 74603

Description: This guide will show the user how to remove the...

Steps:

  1. Rotate the base counterclockwise, supporting the top with your opposite hand.
    2. Step image
  2. Pull the base away from the housing to expose the air filter.
    3. Step image
  3. Grab the edge of the filter housing and pull the filter away from the rest of the device.
    4. Step image
  4. Gently pull apart each fold of the filter to check for abrasions or other anomalies. Clean with a dust rag if necessary.
    5. Step image
  5. Remove all 6 screws from the LED housing.
    6. Step image
  6. After the 6 screws are removed, remove the LED housing from the bottom of the device by lifting it off.
    7. Step image
  7. Using two fingers lift the translucent LED cover from the inside. Repeat this step for the second tab.
    8. Step image
  8. After lifting 45 degrees, pull the translucent tab away from thee housing. Repeat this step for the second LED cover.
    9. Step image
  9. Locate the tab about 1 inch below the top vent. Insert a flat tool laterally past the tab and press in toward the center of the device. As the tab is being held down, pull the two halves of the egg apart to keep the shell open.
    10. Step image
  10. Locate the second tab on the back of the device approximately 2 inches above the power cord.
  11. Insert the flat tool at a slight angle toward the left of the power cord. Depress the tab and pull the two halves of the shell apart.
    12. Step image
  12. Locate the bottom tab on the front side at the same height as the bottom tab on the back side.
  13. Depress the tab using a flat tool at a slight angle and pull the halves apart.
    14. Step image
  14. Locate the last tab about one inch below the top on the front side.
  15. Depress the tab using the flat tool at a slight angle and finish pulling the removable half of the shell off.
    16. Step image
  16. Locate the screw housing opposite of the control board, and remove the screw.
    17. Step image
  17. Locate the control board and grab it by the top and bottom firmly. Pull the board straight out being careful not to flex the circuit while removing.
    18. Step image
  18. Locate the screw that was being hidden by the control board and remove it to release the second half of the shell.
    19. Step image
  19. Remove the released half of the shell to finish removing the entire outer shell of the device.
    20. Step image
Back